$ $ $ $ $
• • • • •

Personalised photo lamp
A few friends asked me to make these for them to give to family members for Christmas.
I cut the material so it would wrap around the lamp shade then printed the right sized photos onto the iron on paper.
Then I ironed the photos on the material making sure they were going to fit on the side of the lamp shade.
I used a hot glue gun to secure the material onto the lamp shade.
Just use a light bulb with low watt's because i'm not sure how the transfer would handle too much heat but noone has had a problem so far.

Posted by Elle-Jay from Gladstone, Queensland, Australia • Published See Elle-Jay's 8 projects »

Elle-Jay posted this project as a creation without steps

Here are some similar tutorials to help you make this one!

Made this project? Share your version »


More Projects